Link to an updated version ‼️https://youtu.be/k2atAca9z9k?si=I5JYWS49zQJn60eL

Great job. I am sure someone already mentioned it but you have the hitch mounts bass akwards. You should have mounted the male hitch to the winch and female to the trailer. That way you can use hook just the winch to the truck or any vehicle if needed

Man your welds are beautiful. Very nice work!

I agree great weld, I also agree you set it up backwards.

The same setup could be done on the outside of the trailer with the winch line running under the top bar. This would give more trailer space and double use the area over the cyl. The further away from the deck edge the better the winch angle is when the vehicle is all the way on. IN this case it would be coming out the roller and going nearly straight up the last few feet. Also the torque reaction from the winch position would need a vertical support under the end of the winch so under load the torque would transfer down to the deck edge.

That's a good winch. That's what I have on my 20 ft trailer. It will pull dam near anything. Exp with a snatch block

it all looked good altho i probably would have welded the receiver to the trailer and the other part to the winch so you could use the receiver part for other things like a hook or clevis ir another tool . the receiver is a universal . good work

Have basically the same trailer needing a winch. Plans are a removable setup similarly mounted but with corrections.

I would have put the female on the trailer and male tube on the winch, and done it so the receiver tube didn’t protrude into the trailer. It would have been more universal and you wouldn’t lose any trailer space. But, nice clean work.

Really nice welds, good job! At first, I thought he was going to use the Everlast Tig.

Those are some Awesome welds ! Best i have seen on You Tube

Nice welds dude those are mint

nice job. pretty welds, wish I could do that as easily as you do

You have amazing welds man!